I’m a huge fan of octoprint on raspberry pi. I’m not a huge fan of raspberry pi lately. I’ve heard of le potato and orange pi. Some searching shows that people have done it on both of those.

Does anyone have any experience running it on a small board computer other than raspi?

  • schizo@forum.uncomfortable.business
    link
    fedilink
    English
    arrow-up
    5
    ·
    edit-2
    4 months ago

    Ah, but the thing is there are older platforms than the N100 that are still faster and more expandable than a rPi.

    I have an AliExpress eWaste special that’s a N3350, 6gb of RAM, and 64gb of eMMC storage which was ~$50.

    About the same price as a new Pi, somewhat better performance than a Pi, and at about 4w idle, roughly the same power as a new Pi. Full load is closer to 10w, but we’re talking 3 or maybe 4w more than the Pi in a relatively rare situation for a lot of Pi use cases.

    And, of course, at full clocks, it’s faster than a Pi4 so you are getting something for those watts.

    • fuckwit_mcbumcrumble@lemmy.dbzer0.com
      link
      fedilink
      English
      arrow-up
      2
      ·
      4 months ago

      older platforms

      And use more power. If you’re just doing octoprint then a full ass PC is kinda silly.

      It’s not the pandemic anymore so you can find pis all over the place for their proper price. My local micro center has 25+ zero ws in stock for $8 and that should be plenty for running octoprint. The Zero 2W $15 (current none in stock) and 3A+ $25 (1 in stock) are also a really good values. Even if you go for the Pi4 you can still find the base model for $35 here and there.

      • dual_sport_dork 🐧🗡️@lemmy.world
        link
        fedilink
        English
        arrow-up
        3
        ·
        4 months ago

        Compared to the power consumption of your 3D printer itself, the wattage drawn by an x86 mini-PC system is a rounding error. What, 19 watts burst under “boost” conditions, and 3 to 7 watts otherwise?

        My Qidi X-Max 3 draws roughly 250 watts when printing basic PLA and its hotend and plate are at temperature. During preheat it can touch 400. And that’s without the chamber heater – that alone is rated a 300 watts.

        • fuckwit_mcbumcrumble@lemmy.dbzer0.com
          link
          fedilink
          English
          arrow-up
          2
          ·
          4 months ago

          Sure while the printer is going, but are you ever going to turn the computer off? I’m sure as hell not going to which is why idle consumption matters so much to me.