I am playing with three +/- 3.2 Vf blue LEDs in series on a breadboard, using a 12V battery. I have many different kinds of resistors to choose from.
As explained here at 08:35 and here, to calculate the resistance necessary to protect the LED(s), I subtract the forward voltage from the supplied voltage to first find the voltage drop of the imaginary resistor. Here: 12 - (3.2 x 3) = 2.4 . I then use Ohm’s, dividing the resistor’s voltage drop with the current necessary to drive the LED(s) (as per the manufacturer’s specs? But let’s suppose 20 mA). Here: 2.4 / 0.02 = 120.

- I don’t understand what The Engineering Mindset means by “our resistor needs to remove the remaining voltage”. That sounds like adding up to what the power source supplies. Doesn’t that leave us with 0V to work with, meaning, no work should happen…? Or is the “remaining EXCESS voltage” we’re talking about here?
- In the image, I’m using a honking 1.2kOhm resistor, so how on earth are the LEDs emitting light? Does the above calculation mean that I could keep decreasing the resistance all the way to 120 Ohms-ish and still without them burning out?
Obviously a layperson here, so explain it as if I was five. 🥰
mkwt@lemmy.world
2·8 hours ago- I think they’re talking about what you call “excess” voltage. If you start at any point in the circuit and go all the way around, adding positive battery voltage and negative voltage drops, the result should be 0 V when arrive back at the starting point. The 0 V constraint is physically required because the starting point and ending point of the measurement are the same point.
- You might want to check what the actual voltage across each diode is. If actual voltage drop per diode is lower than you expected, then the drop across the resistor will be higher, and the current in the circuit will be higher (I = V_R / R). It could also be that you have 2 mA LEDs, not 20 mA.

