I’m about to start putting together some simple furniture and one thing I want is to have the option to collapse it, if I need to move it out of a room.
I’ve looked into confirmat screws and those are incredibly strong but have the downside of requiring specialized drill bits to use. These screws I can get easily in my market, in 500 units boxes.
Are there other options I can look into?
Added information
Material to be used will either be OSB3 or plywood.
do not rely on fasteners. Make https://en.m.wikipedia.org/wiki/Campaign_furniture instead. I recomend starting with buying https://lostartpress.com/products/campaign-furniture which has plans for something that will hold up to time.
More important than the screws is the furniture you’re building. Is it a bed? Table? Giant Victorian highboy with a bajillion drawers? The knock-down needs for all of those are different.
So uh… What are you making?
First in the order of business is a bookcase.
If you search for “knockdown bookshelf” you’ll find tons of options. But my preferred way would be:
-
Vertical sides with a dado for each shelf. The top shelf should be set a few inches below the top of the side boards. Use the extra height on the sides for decoration.
-
For the top and bottom shelves (and if you’re doing it tall, maybe also the middle shelf), in addition to the dadoes, make a pair of wide through mortises.
-
The top and bottom shelves get extra long tenons to go through the mortises. They should stick out enough to put a tusk or wedge on the outside.
-
Put all your shelves in, stick the wedges in the tenons, and enjoy your rock solid bookshelf.
Generally speaking, putting the full weight of a shelf onto any screws is a dangerous idea. Screws tend to fall immediately and completely, and that’ll take the whole shelf with it. If you prefer to go screws, still a good idea to add dadoes into your side pieces to hold the weight, and use the screws to hold the sides in place.
I apreciate the suggestion but, at best, that is overly technical and requires tools I don’t have and can’t fit in my house, like a table saw.
Opting for screws, as I see it, will allow me to build around the concept of basic boxes I can put together with a strong conector that does not require skill beyond knowing how to properly operate a hand drill, to then stack to form the final bookcase.
My concern is finding a connector that will allow for repeated assembly and disassembly, if necessary, without sacrificing strenght and ease of use, while minimizing wear and tear of the hole.
Do you have a circular saw? You can do the dadoes in the sides with that by setting up a guide and taking multiple passes. Use a chisel to clean up the base afterward and it’ll be great. For repeatable assembly, maybe go for those threaded inserts combined with hex bolts.
I have but I lack the hability to use it to that level of hability. I’ve tried on very rough work, where precision wasn’t a high requirement, and the results were disastrous.
Practice time! Good luck dude
-
You could either ignore the special bit “requirement” (though with MDF I suspect it’ll be problematic), or reproduce it using two bits, or just buy the bit, it’s $20 on Walmart/Amazon/Ebay, a pittance in the woodworking world.
I know myself well enough to know that trying to emulate the drilling profile required for these screws would result in disastrous outcomes.
Buying the special drill bit is an option, although not on one of those retailers, for geographical reasons, but the money put towards it could be used to buy another type of screw that could offer similar results to the confirmat, with no added tools required.