So my kid has lost a bunch of these shapes and I’m going to make a replacement set.
Does anyone have any ideas for how to get a consistent roundover on the corners? I have a router table but no CNC.
The square and rectangle I could do with a roundover bit and the blocks on their sides. But I don’t see any obvious solutions for the pentagon and triangle.
I’m totally fine just hand sanding these, but this kind of problem solving makes woodworking fun!
You must log in or register to comment.
Could you not just use a router pattern bit and use the actual piece as the template?
This is the way. Tape it down, route it out.
